To configure the workspace selector

Purpose

Perform this procedure to add, remove, or change the sequence of workspaces in the workspace selector, or to set a workspace as the default workspace.

Steps
 

Choose Application→User Preferences from the NFM-P main menu. The User Preferences form opens.


Click on the Workspaces tab. A list is displayed of the workspaces that are currently available in the workspace selector.


Perform any of the following:

  1. Add a workspace to the workspace selector.

    1. Click Add. The Add Workspace form opens. A list is displayed of the workspaces not currently in the workspace selector.

      The Add button is disabled when the Allow Mandatory Workspaces Only check box is selected during user group configuration. See the procedure to add or remove workspaces for a user group in the NSP System Administrator Guide.

    2. Choose a workspace from the list and click OK.

  2. Set the default workspace that displays when the NFM-P opens. Choose a workspace in the list and click Set as Default.

  3. Remove a workspace from the workspace selector. Choose a workspace in the list and click Delete.

    You cannot remove a workspace when that workspace is set as the default workspace.

    You cannot remove a workspace that is listed as a mandatory workspace in your user group.

  4. Change the sequence of workspaces in the workspace selector. Choose a workspace and click Move Up or Move Down.


Save your changes and close the form.

Note: If the current workspace is deleted from the workspace selector, the workspace selector displays “Workspace Out of Sync”.

End of steps