To verify that SSH2 is enabled on a device
Purpose
Perform this procedure to verify that SSH2 is enabled on a device, and to enable SSH2 on the device, if required.
Steps
1 |
Open a CLI session on the device. |
2 |
Run the following CLI command to see whether SSH2 is enabled: show system security ssh ↵ |
3 |
If required, enter the following command at the prompt to enable SSH2: configure system security ssh version 2 ↵ Note: A 7705 SAR may become temporarily unreachable after you enable SSH and start the SSH server on the device. |
4 |
Close the CLI session. |
5 |
If you are performing this procedure for device discovery, see Workflow for device discovery for the next steps. End of steps |