To configure Cflowd collectors on an ISA-AA group or partition

Before you begin

You can configure Cflowd collectors on an ISA-AA group, and on partitions within the group. The options differ, depending on whether you configure a group or partition.

Steps
 
1 

If you are performing this procedure as part of the ISA-AA group or partition configuration described in To configure an ISA-AA group and ISA-AA partitions , go to Step 4 .

2 

On the Equipment tree, expand [NE]→Logical Groups→ISA-AA Groups→ISA-AA Group n.

3 

Right-click on the ISA-AA Group n icon and choose Properties. The ISA-AA Group (Edit) form opens.

If you are configuring Cflowd on an ISA-AA partition, go to Step 7 .

4 

Click on the CFLOWD tab and configure the required parameters on the General tab.

5 

Click on the Collector tab.

  1. Click Create or select an existing collector entry and click Properties. The Cflowd Collector (Create|Edit) form opens.

  2. Configure the required parameters.

  3. Save your changes and close the form

    Note:

    An ISA-AA group can contain a maximum of two Cflowd collectors.

6 

Go to Step 11 .

7 

Click on the ISA-AA Partitions tab.

8 

Select a partition in the list and click Properties. The ISA-AA Group Partition (Edit) form opens.

9 

Click on the CFLOWD tab.

10 

To add an AA application or application group for Cflowd performance monitoring, click on the Performance tab. Otherwise, go to Step 13 .

11 

To add an AA application for Cflowd performance monitoring:

  1. Click Add Applications RTP, Add Applications Comprehensive, or Add Applications TCP. The Select Applications form opens.

  2. Select one or more applications and click OK.

12 

To add an AA application group for Cflowd performance monitoring:

  1. Click Add Application Groups RTP, Add Application Groups Comprehensive, or Add Application Groups TCP. The Select Application Groups form opens.

  2. Select one or more application groups and click OK.

13 

To set the Cflowd sampling administrative states, click on the States tab and configure the required parameters.

14 

Configure direct Cflowd export, if required.

  1. Click on the Direct Export tab.

  2. Configure the Direct Export VLAN parameter.

  3. Click on the Collectors tab.

  4. Click Create. The CFLOWD Direct Export Collector (Create) form opens.

    Note:

    You can create only one collector.

  5. Configure the parameters.

  6. Click Create. The CFLOWD Direct Export Collector Address (Create) form opens.

    Note:

    You can add a maximum of two host address entries.

  7. Configure the parameters.

  8. Click OK. The CFLOWD Direct Export Collector Address (Create) form closes.

  9. Repeat Step 14 6 to 8 to create an additional host address, if required.

    You can view the statistics for a collector host on the Statistics tab of the collector host properties form.

15 

Save your changes and close the forms.

End of steps