To configure OmniSwitch dynamic LAG members
Note: LAG members are not added during the creation of the dynamic LAG, as they are with static LAGs. When a new dynamic LAG member is created it is placed into the Unassigned Dynamic LAG Members object. The new dynamic LAG members remain under the Unassigned Dynamic LAG Members object until the system identifies a LAG with matching properties. When an unassigned LAG member joins a LAG, the member is removed from the Unassigned Dynamic LAG Members object and added to the appropriate LAG object.
When a port is assigned to a LAG member, you cannot modify the port properties using the NFM-P.
Steps
1 |
On the equipment navigation tree, expand Network→NE→Logical Groups. |
2 |
Right-click on the Unassigned Dynamic LAG Members object and choose Create LAG Members. The Create LAG Member wizard opens. |
3 |
Configure the Show Only Compatible Ports and Class parameters. |
4 |
Click Next. The Create LAG Member - Select Ports step displays. |
5 |
Choose up to the maximum number of ports you require from the list of ports to create the LAG. You can select more than one port at a time from the list. Note: If there are no compatible ports to choose from and you want to edit some of the existing ports to be compatible, then disable the Show Only Compatible Ports parameter. Click Next. Choose ports to edit from the list and click Properties. For all ports in an LAG, you must disable auto-negotiation, configure the same speed, and set the ports to full duplex. Mobile ports cannot be part of a LAG. |
6 |
Configure the required parameters. |
7 |
Click Finish. Save your changes and close the form. End of steps |