To configure WLAN GW redundancy on an NE
Purpose
Perform this procedure to configure a virtual chassis identifier on an NE for the purpose of fail-over redundancy in WLAN GW configurations. You must perform this procedure on each NE in the redundancy configuration. The NEs must all use the same virtual chassis ID string or dual homing key.
Steps
1 |
On the equipment tree, right-click on an NE and choose Properties. The Network Element (Edit) form opens. |
2 |
Click on the Globals tab, then on the WLAN GW Sys Config tab. |
3 |
Configure the Virtual Chassis ID and Max Number of GTP Session Held parameters. |
4 |
Save your changes and close the form. End of steps |