To configure port-based scheduling on the 7210 SAS
Purpose
Using the global system resource profile, you can configure access ports on the 7210 SAS-Mxp or 7210 SAS-R to use either port-based or SAP-based egress scheduling. When port-based scheduling is enabled, the port supports eight egress queues, and all SAPs on the port share the same set of eight queues.
Queues for port-based scheduling are configured in the 7210 port access egress policy assigned to the port; see To configure a 7210 and 1830 port access egress policy . See Sample QoS configuration on the 7210 SAS for more information about configuring scheduling on the 7210 SAS-Mxp and 7210 SAS-R.
SAP-based egress queues are not available when port-based scheduling is enabled. See the NE documentation for more information.
You must enable port-based scheduling before configuring egress meters.
Steps
1 |
On the equipment tree, right-click on the required NE and choose Properties. The Network Element (Edit) form opens. |
2 |
Click on the Globals tab, then click on the System Resource Profile tab. |
3 |
Configure the Port Scheduler Mode (Configured) parameter. Changes to the Port Scheduler Mode (Configured) parameter require a reboot of the NE to take effect. The Port Scheduler Mode (Active) parameter displays the parameter setting currently in effect on the NE. |
4 |
Save your changes and close the form. End of steps |