To configure a new PIN value for a cellular carrier

When to use

Each new 7750 SAR-Hm node that is discovered by the NFM-P may have a default PIN applied to each SIM for security and access rights.

The PIN is configured on a per carrier basis. If a single SIM layout is in use, a single PIN is configured for the domain and applied to all sites. In a dual SIM layout, a PIN is configured for each carrier and applied to all sites for the SIM that applies to that carrier.

You can globally apply and deploy a new security PIN during the ADP or from domains that contain discovered nodes. When a PIN is configured during the domain creation, all subsequent nodes added to the domain through the ADP will have the new PIN applied for the carrier.

Note: Before starting this procedure, you must first create the cellular domain and at least one 7705-SAR Hm node must be present in the domain; see To configure a cellular domain with single SIM deployment or To configure a cellular domain with dual SIM deployment..

Steps
 

Choose Manage→Cellular Domain from the NFM-P main menu. The Cellular Domain Manager form opens.


Click Search and choose the cellular domain that you want to configure a new PIN value for. The Cellular Domain [Edit] form opens.


On the General tab, disable the Enable ADP parameter.


If Dual SIM is in use, choose a carrier and click Properties. The Cellular Carrier (Edit) form opens.


Enter a new value for the New PIN parameter.


Click Apply to save the form and deploy the new PIN entry to all 7705 SAR-Hm nodes in the domain.


On the General tab, click the Enable ADP parameter if you want all subsequent nodes added to the domain to have the same PIN applied to them.


Close the form.

End of steps