To create a 7210 SAS SHG
Before you begin
Traffic that arrives on a access or access uplink port or LAG within an SHG is not copied to other ports and LAGs in the same SHG; the traffic is copied to ports and LAGs in other SHGs if they exist within the same VPLS. Ports and LAGs are added to an SHG when you configure a port or LAG on a 7210 SAS. SHGs are not supported for a VPLS instance.
Note: SHG creation is only supported on specific 7210 SAS variants; see the NE documentation for more information.
Steps
1 |
On the equipment tree, right-click on the device where you want to configure the SHG and select Properties. The Network Element (Edit) form opens. |
2 |
Click on the Split Horizon Groups tab. |
3 |
Click Create. The Split Horizon Group (Create) form opens. |
4 |
Configure the required parameters and click OK. Note: Only one SHG can be configured per service. A SHG and a Mesh SDP Binding cannot exist simultaneously on a single service. |
5 |
Repeat Step 3 to Step 4 to add another SHG, if required. |
6 |
Save your changes and close the form. End of steps |