To configure a 7705 SAR ASAP channelized TDM port
Before you begin
This procedure applies to 7705 SAR channelized TDM DS1/E1 ports and channelized TDM DS3/E3 ports.
Steps
1 |
On the equipment tree, navigate to the port object where you want to configure a 7705 SAR ASAP channelized TDM port. The path is Network→NE→Shelf→Card Slot n→Daughter Card Slot n→Port n/n/n. |
2 |
Right-click on a port object that contains a channelized port (DS1/E1 or DS3/E3) and choose Properties. The Physical Port (Edit) form opens. |
3 |
Configure the required parameters. |
4 |
Click on the DS1/E1 or DS3/E3 tab and configure the required parameters. All ports of the ASAP daughter card are automatically configured to the same port type when the first port is configured. A mix of DS1 and E1 ports or DS3 and E3 ports is not supported. The Port Type parameter can only be modified when no channels are configured on any port of the daughter card. If all of the channels are deleted on the daughter card, the port type is automatically set to DS1 or DS3 for all ports. |
5 |
Click on the States tab and configure the Administrative State parameter. |
6 |
Save your changes and close the form. End of steps |