To run an OAM validation test on a service tunnel
Purpose
Use this procedure to run an OAM validation test on a service tunnel. An OAM validator test suite must be created for the tested entity; see Chapter 89, Service Test Manager .
Note: Alternatively, you can also run an OAM validation test on the service tunnel by performing a one-time validation; see To run a one-time validation test on a service .
Steps
1 |
Choose Manage→Service Tunnels from the NFM-P main menu. The Manage Service Tunnels form opens |
2 |
Click Search, choose a service tunnel, and click Properties. The Tunnel (Edit) form opens. |
3 |
Click Validate. If an OAM validator test suite is not associated with the service tunnel, a dialog box appears. Click OK, choose an OAM validator test suite, and click OK. |
4 |
View the State Cause indicators. When the validation test fails, a check mark appears beside the OAM Validation Failure indicator. |
5 |
Click on the Tests tab, then on the Tested Entity Result tab. |
6 |
Choose an entry and click Properties. The Tested Entity Result (Edit) form opens. |
7 |
Click on the Results tab to display the validation test results. |
8 |
If you need to compare two test results from the same type of test, choose the two test results and click Compare. The Difference form opens. Otherwise, go to Step 10 . |
9 |
Compare the test results. |
10 |
Close the forms. End of steps |