LSPs parameters
Auto Select Hop-less Path
The Auto Select Hop-less Path parameter specifies whether MPLS paths are explicitly specified during LSP creation or the LSP uses a completely loose path and the NFM-P selects the MPLS paths for the LSP.
Table A-20: Auto Select Hop-less Path parameter
|
Option |
Option description |
|---|---|
|
Disabled (default) |
Specifies that you must manually choose or create the MPLS paths during LSP creation based on the source NE. IGP is used to identify the next hop. |
|
Enabled |
Specifies a loose path. The NFM-P chooses the MPLS paths for the LSP. If no hopless path to the destination exists, the NFM-P creates one. |
Note: If the Auto Select Hop-less Path parameter is enabled, the NFM-P automatically creates a hopless MPLS path for the dynamic LSP. This path will be named “HOP-LESS PATH <system_IP_adress>-<ID>”, where the system_IP_address is the source NE address and the ID is the unique identifier for the MPLS. If you want to create an MPLS path and use the Auto Select Hop-less Path parameter to assign it to the LSP, it must follow this naming convention.
Exclude Node in ERO
The Exclude Node in ERO parameter specifies whether or not a device should be excluded from the manual bypass LSP path.
When this parameter is enabled, you can enter an IPv4 address for the Exclude Node IP Address parameter.
The options are:
View the newly created Bypass Only Lsp
The View the newly created Bypass Only Lsp parameter specifies whether you want to view the configuration information about the newly created LSP. The Bypass Only LSP child form displays the service tunnel configuration information.
The options are:
View the newly created Dynamic LSP
The View the newly created Dynamic LSP parameter specifies whether you want to view the configuration information about the newly created LSP. The Dynamic LSP child form displays the service tunnel configuration information.
The options are: