To configure an IPsec traffic selector list

Steps
 

Choose Policies→ISA Policies→IPsec Policies from the NFM-P main menu. The IPsec Policies form opens.


Click Create→Traffic Selector List, or choose a list and click Properties. The IPsec Traffic Selector List (Create|Edit) form opens.


Configure the List Name parameter.


Click on the Local Entries tab.


Click Create. The IPsec TS Local List Entry (Create) form opens.


On the General tab, perform one of the following:

  1. Set the Address Format parameter to None.

  2. Set the Address Format parameter to Range Address and configure the From IP Address and To IP Address parameters.

  3. Set the Address Format parameter to Prefix and configure the IP Prefix and Prefix Length parameters:


On the Protocol tab, perform one of the following.

  1. Choose Any.

  2. Choose a specific protocol option and a port option. If you choose the Manual port option, you need to configure the minimum and maximum port parameters.

  3. Choose Manual and configure a Protocol ID.


Save your changes and close the IPsec TS Local List Entry (Create) form.


Distribute the policy to NEs.


10 

Close the IPsec Traffic Selector List (Create|Edit) form.


11 

Close the IPsec Policies form.

End of steps