To enable BFD for a static LAN-to-LAN IPsec tunnel
Steps
1 |
On the private side, use the device CLI to specify a tunnel and to enable BFD on the tunnel. Note: See the device documentation for information about the CLI commands required to perform the action. |
2 |
On the public side, use the device CLI to configure the transmit interval. Note: See the device documentation for information about the CLI commands required to perform the action. |
3 |
Create a tunnel interface in a VPRN service, as described in To configure a tunnel interface on an IES or VPRN. |
4 |
Create an IPsec tunnel on the tunnel interface, as described in To configure an IPsec tunnel on a VPRN tunnel interface. |
5 |
Close all open forms. End of steps |