To configure MC IPsec on a VPRN tunnel interface
Purpose
Perform this procedure to configure MC IPsec to move traffic to the master NE in the event that the standby NE receives traffic.
Note: The port configured on the tunnel must be created using a tunnel SAP. For example, tunnel-x.private/public:y. See
To configure a tunnel interface on an IES or VPRN for more information.
Steps
| |
|
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.
|
2 |
Click Search. A list of services is displayed.
|
3 |
Select a VPRN service and click Properties. The VPRN Service (Edit) form opens.
|
4 |
Click on the Tunnel Interfaces tab.
|
5 |
Choose a tunnel interface and click Properties. The Tunnel Interface (Edit) form opens.
|
6 |
Configure the Redundant Next-Hop IP Address for Static ISA Tunnels and Redundant Next-Hop IP Address for Dynamic ISA Tunnels parameters.
Note: The next hop address that you specify is used by the standby NE to shunt traffic to the master NE in the event that the standby receives traffic. The next hop address is resolved in the routing table of the corresponding service.
|
7 |
Click OK. The Tunnel Interface (Edit) form closes.
|
8 |
Close the VPRN Service (Edit) form.
|
9 |
Close the Manage Services form.
End of steps |