To configure MC IPsec on an IES or VPRN L3 access interface

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Click Search, select an IES or VPRN service, and click Properties. The IES Service (Edit) or VPRN Service (Edit) form opens.


In the service navigation tree, expand the Sites icon, and then the icon of the Site or Routing Instance that hosts the L3 access interface.


Expand the L3 Access Interfaces icon and select the required L3 access interface.


Configure the Redundant Next-Hop IP Address for Static ISA Tunnels and Redundant Next-Hop IP Address for Dynamic ISA Tunnels parameters.

Note: The parameters are configurable only when the port on the interface is created with a tunnel SAP. For example, tunnel-x.private/public:y.

The next hop address that you specify is used by the standby NE to shunt traffic to the master NE if the standby receives traffic. The next hop address is resolved in the routing table of the corresponding service.


Click OK. The IES Service (Edit) or VPRN Service (Edit) form closes.


Close the Manage Services form.

End of steps