To configure an MC peer

Purpose

Perform this procedure to correct a configuration mismatch between the peers in an MC peer group by modifying an MC peer configuration.

Note: The MC peer parameters are configurable only when there is a configuration mismatch, which is indicated when the Neighbor Match check box on the MC Peer (Edit) form is disabled.

Steps
 

Choose Manage→Redundancy→Node Redundancy from the NFM-P main menu. The Manage Node Redundancy form opens.


Choose MC Peer Group (Multi-Chassis) from the drop-down menu and click Search.


Click Create or select an MC peer group and click Properties. The MC Peer Group (Create|Edit) form opens.


Click on the Members tab.


Select a peer and click Properties. The MC Peer (Edit) form opens.


Configure the required parameters.


Click on the MC LAG tab and configure the parameters, as required.


Click on the Synchronization Protocol tab to configure MC synchronization group parameters.

Use the following steps:

  1. Click Create or select an entry and click Properties. The MC Sync (Create|Edit) form opens.

  2. Configure the required parameters on the General tab.

  3. Click on the States tab to configure the Administrative State parameter for the synchronization protocol.

  4. Click on the Track SRRP tab to configure a track SRRP instance for the synchronization protocol.

  5. Click Create or select an existing track SRRP instance and click Properties. The Track SRRP (Create|Edit) form opens.

  6. Configure the required parameters.

    The MCS State Disabled check box must be un-checked in order to configure the L2TP Tunnel ID Range Start and End parameters.

  7. Save your changes and close the form.


Save your changes and close the remaining forms.

End of steps