To create an MC AOS group

Steps
 

Choose Manage→Redundancy→Node Redundancy from the NFM-P main menu. The Manage Node Redundancy form opens.


Choose MC AOS Group (Aos Redundancy) and click Create. The MC AOS Group (Create) form opens.


Configure the required parameters.


Perform one of the following.

  1. Configure the parameters in the First MultiChassis (Chassis Id 1) panel.

  2. Select an OmniSwitch in the First MultiChassis (Chassis Id 1) panel and click OK.


Perform one of the following.

  1. Configure the parameters in the Second MultiChassis (Chassis Id 2) panel.

  2. Select an OmniSwitch in the Second MultiChassis (Chassis Id 2) panel and click OK.


Perform one of the following.

  1. Configure the IPC VLAN Site ID parameter.

  2. Enable the Default parameter.


Configure the remaining parameters.

Note: The Primary Minimum Lag Id and Primary Maximum Lag Id parameters are configurable only when the Configure Primary Lag Range parameter is enabled.

The Secondary Minimum Lag Id and Secondary Maximum Lag Id parameters are configurable only when the Configure Secondary Lag Range parameter is enabled.

The Minimum MCLag Id and Maximum MCLag Id parameters are configurable only when the Configure MultiChassis Lag Range parameter is enabled.


Right-click on MC AOS LAG Group and choose Create MC AOS LAG Group. The MC AOS LAG Group (Create) form opens.


Configure the Lag ID parameter.


10 

Save your changes and close the forms.

End of steps