To configure an MC AOS group member
Steps
1 |
In the navigation tree equipment view, right-click on an OmniSwitch NE and choose Properties. The Network Element (Edit) form opens. |
2 |
Click on the MultiChassis tab and configure the required parameters. |
3 |
Click on the Lag Ranges tab and configure the required parameters. Note: The Local Minimum Lag ID and Local Maximum Lag ID parameters are configurable only when the Configure Local Lag Range parameter is selected. The Peer Minimum Lag ID and Peer Maximum Lag ID parameters are only configurable when the Configure Peer Lag Range parameter is selected. The Minimum MCLag ID and Maximum MCLag ID parameters are only configurable when the Configure Local Lag Range parameter is selected. |
4 |
Click on the Loopback Detection tab. |
5 |
Configure the Admin Status and Transmit Interval (seconds) parameters. |
6 |
Save your changes and close the form. End of steps |