To create a Dynamic or segment routing LSP from a tunnel template

Purpose

Before you can create an LSP from a tunnel template, you must create the tunnel template. You can use an existing LSP to create a tunnel template.

Steps
 

Choose Manage→MPLS→(Dynamic|Segment Routing) LSPs from the NFM-P main menu. The Manage (Dynamic|Segment Routing) LSPs form opens.


Click Create from Template. A Create (Dynamic|Segment Routing) LSP from Template form opens with a list of tunnel templates.


Choose a template and click OK. A Create (Dynamic|Segment Routing) LSP from Template form opens.


Configure the required parameters.


Specify the source sites for the LSP.

  1. Select a Source Site ID and click OK.

  2. Select a Source IP Address and click OK.


Configure the Destination Site ID and the Destination IP Address parameters.


Click on the Accounting tab and select an accounting policy.


Click OK.


Configure the Collect Accounting Statistics and the Administrative State parameters.


10 

Click on the Properties tab and configure the required parameters.

Note: The number of parameters that can be configured depends on how the template was created. All of the parameters are configurable when the template is based on an object. A subset of the parameters can be configured when the template is based on an object class.


11 

Click OK. The Create (Dynamic|Segment Routing) LSP from Template form closes.


12 

When the Show Created Object parameter is enabled on the template, the (Dynamic|Segment Routing) LSP (Edit) form opens. Close the (Dynamic|Segment Routing) LSP (Edit) form.


13 

Close the Manage (Dynamic|Segment Routing) LSPs form.

End of steps