To configure an IGMP interface

Purpose

Before an IGMP interface can be configured, the following prerequisites must be met:

Note: IGMP IPv6 interfaces are supported on the 7950 XRS, on the 7750 SR in chassis mode A or B with mixed mode enabled, and on the 7750 SR in chassis mode C or D.

The tabs and parameters that are configurable vary, depending on the NE on which the IGMP site resides.

Steps
 

In the navigation tree Routing view, expand Network→NE→Routing Instance→IGMP.


Right-click on the IGMP icon and choose Create Interface, or right-click on an existing IGMP interface and choose Properties. The IGMP Interface (Create|Edit) form opens.


Select a Layer 3 interface in the Interface panel.


Configure the required parameters.


Click on the Behavior tab.


Select an import policy, and configure the required parameters.


To configure multicast CAC:

Perform the following steps:

  1. Click on the Multicast CAC tab

  2. Select a multicast CAC policy in the Multicast CAC Policy panel.

  3. Configure the required parameters.

  4. Click on the Levels tab.

  5. Click Create or select an existing multicast CAC level entry and click Properties. The Multicast CAC Level (Create|Edit) form opens.

  6. Configure the required parameters.

  7. Save your changes and close the form.

  8. Click on the LAG Port Down tab.

  9. Click Create or select an existing LAG port down entry and click Properties. The LAG Port Down (Create|Edit) form opens.

  10. Configure the required parameters.

  11. Save your changes and close the form.


Click on the SSM Translation tab to configure SSM translation entries.

Perform the following steps:

  1. Click Create or select an existing SSM translation entry and click Properties. The SSM Translation (Create|Edit) form appears.

  2. Configure the required parameters.

  3. Save your changes and close the form.


Click on the Static Group/Source tab to create a static multicast entry.

Perform the following steps:

  1. Click Create or select an existing static multicast entry and click Properties. The Static Grp Src (Create|Edit) form appears.

  2. Configure the required parameters.

  3. Save your changes and close the form.


10 

Save your changes and close the form.

End of steps