To configure a VPLS SAP template policy

Steps
 

Choose Manage→Service→SAP Template Policies from the NFM-P main menu. The Manage Service SAP Template Policies form opens.


Click Create→VPLS SAP Template or select an existing VPLS SAP template policy and click Properties. The VPLS SAP Template (Create|Edit) form opens.


On the General tab, configure the required parameters.

An epipe SAP template policy cannot share the same object name as a VPLS SAP template policy if both policies are distributed to the same NE. Although both policies could co-exist in the NFM-P database, the NE stores both policy types in the same MIB table, which would cause a conflict.


Select a DoS protection policy, if required.

If you configure a DoS protection policy on the VPLS SAP template policy, you can configure the CPM Monitor MAC parameter or select ETH CFM Monitoring options.


Click on the Ingress tab to configure ingress filter, QoS, and scheduler policies for the VPLS SAP template policy.

  1. Select the following policy types, as required:
    • IP filter

    • IPv6 filter

    • MAC filter

    • QoS

    • QoS scheduler

    • Policer control

  2. Configure the remaining parameters.


Click on the Egress tab to configure egress filter, QoS, and scheduler policies for the VPLS SAP template policy.

  1. Select the following policy types, as required:
    • IP filter

    • IPv6 filter

    • MAC filter

    • QoS

    • QoS scheduler

    • Policer control

  2. Configure the remaining parameters.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps