Sample network QoS configuration

Overview
Figure 70-19: Example of a service configuration using QoS
Example of a service configuration using QoS
Workflow to configure network QoS

Note: In this configuration, the following services are provisioned:

The cumulative rate at site A needs to be limited to 70 Mb/s.

The following high-level steps are required to create the Figure 70-19, Example of a service configuration using QoS configuration with rate limiting using QoS at Site A. Similar steps are required to configure QoS for Subscriber 1 on Sites B and C:

 

Configure a scheduler policy.


Create Subscriber 1.


Create the aggregation scheduler for Subscriber 1 on site A and assign ingress and egress scheduler policies to the aggregation scheduler.


Create IES, VLL, and VPLS for Subscriber 1.

  • Specify sites for the services.

  • Specify access interfaces for the sites.

  • Specify the aggregation scheduler policy for the access interfaces.

  • Bind the services to tunnels for transport through the IP/MPLS network.