To configure an AA session filter

Purpose

Perform this procedure to create an AA session filter for an AQP. See To configure an AQP for information about configuring an AQP.

Steps
 

Choose Policies→ISA Policies→Application Assurance from the NFM-P main menu. The Application Assurance Policies form opens.


Click Create→AA Session Filter or select an AA session filter entry and click Properties. The AA Session Filter (Create | Edit) form opens.


Configure the parameters.


Click on the Entries tab and click Create. The AA Session Filter Params (Create) form opens.


Configure the parameters.


If you set the Action parameter to HTTP Redirect, choose an HTTP redirect policy.


Click on the Match Criteria tab and configure the Protocol Number parameter.


Perform one of the following in either or both of the Source Address and Destination Address panels.

  1. Specify a single IP address or prefix by configuring the Address and Length parameters.

  2. Choose an IP prefix list.


If required, choose a DNS IP cache in the Destination Address panel.


10 

If the Protocol Number parameter is set to SCTP, TCP, or UDP, configure the parameters in the Source Port and Destination Port panels.


11 

Save your changes and close the form.


12 

Repeat Step 5 to Step 11 to add another filter entry, if required.


13 

Save your changes and close the forms.

End of steps