To create an NE LI user profile on an NE using a CLI
Steps
You require NFM-P admin privileges to perform this procedure.
1 |
Open an SSH session on the NE as described in Chapter 10, Device CLI sessions . |
2 |
Enter the following commands in sequence at the prompt to create an NE LI user profile. The following is a sample configuration: configure system security profile li-prof ↵ default-action deny-all ↵ li ↵ entry 10 ↵ match “configure li” ↵ action permit ↵ exit ↵ entry 20 ↵ match “exit” ↵ action permit ↵ exit ↵ entry 30 ↵ match “help” ↵ action permit ↵ exit ↵ entry 40 ↵ match “back” ↵ action permit ↵ exit ↵ entry 50 ↵ match “show li” ↵ action permit ↵ exit ↵ entry 60 ↵ match “info” ↵ action permit ↵ exit ↵ entry 70 ↵ match “configure system security user” ↵ action permit ↵ exit ↵ entry 80 ↵ match “admin save” ↵ action permit ↵ exit ↵ exit all ↵ admin save ↵ |
3 |
Close the SSH session. |
4 |
Right-click on the NE in the NFM-P topology map and choose Resync→Resync All MIBs from the contextual menu to update the NE configuration in the NFM-P. End of steps |