To configure a queue group ingress template policy

Steps
 

Choose Policies→QoS→SROS QoS→Queue Group→Ingress Template from the NFM-P main menu. The Ingress Queue Group Template Policies form opens.


Click Create or choose an existing ingress queue group template policy and click Properties. The Ingress Queue Group Template (Create | Edit) form opens.


Configure the required parameters.


Click on the Queues tab.


Click Create or choose an existing queue and click Properties. The Ingress Queue (Create | Edit) form opens.


Configure the required parameters.


Configure the Named Buffer Pool parameter:

  1. Click on Select adjacent to the Named Buffer Pool parameter. The Named Buffer Pool form opens.

    Note:

    To configure the Named Buffer Pool parameter, you must first create a Named Buffer Pool policy. See To configure a named buffer pool policy .

  2. Select the required policy and click OK.


Configure the Scheduler parameter:

  1. Click on Select adjacent to the Scheduler parameter. The Schedulers form opens.

  2. Select the required scheduler and click OK.

  3. Configure the required parameters in the Scheduler Association panel.


Configure the Advanced Configuration Policy Displayed Name parameter:

  1. Click Select in the Advanced Configuration Policy panel. The Select Advanced Configuration Policy search form opens.

  2. Select the required policy and click OK.


10 

Configure the CIR/PIR/FIR parameters:

  1. Click on the CIR/PIR/FIR tab.

  2. Configure the required parameters.

    Ensure that the CIR value is lower than the PIR value.


11 

Configure the Burst Size parameters:

  1. Click on the Burst Size tab.

  2. Configure the required parameters.

    The parameters are configurable when the Default check box above each is deselected.

    Ensure that the Committed Burst Size (kb) value is lower than the Maximum Burst Size (bytes) value.

  3. Click OK.


12 

Click on the Policers tab.


13 

Click Create or choose an existing policer and click Properties. The Ingress Policer (Create | Edit) form opens.


14 

Configure the required parameters.


15 

Configure the Advanced Configuration Policy Displayed Name parameter:

  1. Click Select in the Advanced Configuration Policy panel. The Select Advanced Configuration Policy search form opens.

  2. Select the required policy and click OK.


16 

Configure the CIR/PIR parameters:

  1. Click on the CIR/PIR tab.

  2. Configure the required parameters.


17 

Configure the Burst Size parameters:

  1. Click on the Burst Size tab.

  2. Configure the required parameters.

    The parameters are configurable when the Default check box above each is deselected.

  3. Click OK.


18 

Click OK to save the policy and close the form.

End of steps