To configure an HSMDA WRED slope policy

Steps
 

Choose Policies→QoS→SROS QoS→Slope→HSMDA WRED Slope from the NFM-P main menu. The HSMDA Slope Policies form opens.


Click Create or choose a policy and click Properties. The HSMDA Slope Policy (Create|Edit) form opens.


Configure the general parameters.


Click on the HSMDA Burst Size tab. The Burst Size form opens, as shown in Figure 50-5, HSMDA Slope Policy form - Burst Size .

Figure 50-5: HSMDA Slope Policy form - Burst Size
HSMDA Slope Policy form - Burst Size

Each buffer pool supports a high-priority RED slope and a low-priority RED slope. The high-priority RED slope manages access to the shared portion of the buffer pool for high-priority or in-profile packets. The low-priority RED slope manages access to the shared portion of the buffer pool for low-priority or out-of-profile packets. See  Slope policies in this chapter for more information.


Configure the parameters for the Low Slope and the High Slope and click Apply. The HSMDA Slope Policy form is refreshed with additional buttons.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps