To configure an HSMDA scheduler policy
Steps
1 |
Choose Policies→QoS→SROS QoS→Scheduler→HSMDA Scheduler from the NFM-P main menu. The HSMDA Scheduler Policies form opens. |
2 |
Click Create or choose a policy and click Properties. The HSMDA Scheduler Policy (Create) form opens. |
3 |
Configure the required general parameters. |
4 |
Click on the HSMDA Group Rates tab and configure the required parameters for Group 1 and Group 2. |
5 |
Click on the HSMDA Scheduler Classes tab and configure the parameters for classes 1 to 8. The Group parameter must be configured with the same group (Group 1 or Group 2) for up to three sequential classes for each group. For example, when you configure Class 1 as Group 2, you can configure Class 2 and Class 3 as Group 2, but not as Group 1. The Rate (Mbps) and Burst Limit (bytes) parameters are configurable when the Group parameter is set to None. The Weight parameter is configurable when the Group parameter is set to a value other than None. |
6 |
Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs. End of steps |