To configure a distributed subscriber management IP filter policy

Steps
 

Choose Policies→Residential Subscriber from the NFM-P main menu. The Residential Subscriber Policies form opens.


Click Create→Distributed Subscriber Management IP Filter Policy or select an existing policy item and click Properties. TheDistributed Subscriber Management IP Filter Policy (Create|Edit) form opens.

Modifying an active distributed subscriber management IP filter policy is potentially service-affecting. Ensure that you consider the implications of reconfiguring the policy before you proceed.


Configure the required parameters.


Click on the IPv4 Filter Entries tab to configure IPv4 filter entries.


Click Create to create a new filter entry or select an existing filter entry and click Properties. The DSM IPv4 Filter Entry (Create|Edit) form appears.

  1. Configure the required parameters.

    The Port parameter is configurable if the Protocol parameter is set to TCP or UDP.

  2. Save your changes and close the form.


Click on the IPv6 Filter Entries tab to configure IPv6 filter entries.


Click Create to create a new filter entry or select an existing filter entry and click Properties. The DSM IPv6 Filter Entry (Create|Edit) form appears.

  1. Configure the required parameters.

    The Port parameter is configurable if the Protocol parameter is set to TCP or UDP.

  2. Save your changes and close the form.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policer to NEs.

End of steps