To configure a diameter policy

Steps
 

Choose Policies→Residential Subscriber from the NFM-P main menu. The Residential Subscriber Policies form opens.


Click Create→Diameter Policy or choose an existing diameter policy and click Properties. The Diameter Policy (Create|Edit) form opens.

Modifying an active diameter policy is potentially service-affecting. Ensure that you consider the implications of reconfiguring the diameter policy before you proceed.


Configure the required parameters.

If you set the Virtual Router Type parameter to VPRN Service, you must also specify a VPRN service.


Click on the DCAA Parameters tab and configure the required parameters.


Click on the Peers tab to configure diameter peers.

  1. Click Create or choose an existing diameter peer entry and click Properties. The Diameter Peer (Create|Edit) form opens.

  2. Configure the required parameters.

    If you want to specify local override settings for any of the timer settings for the peer, disable the Inherit Value check box and then specify a value for any of the timer parameters:
    • Watchdog Timer (seconds)

    • Connection Timer (seconds)

    • Transaction Timer (seconds)

    When the Inherit Value check box is selected for a timer parameter on a peer object, the timer value is inherited from the parent diameter policy.

  3. Save your changes and close the form.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps