To configure a multicast redirect interface on a local routing policy statement

General Information

To perform this procedure, you must use a global routing policy statement that has been released and distributed to one or more NEs. See To configure a routing policy statement for more information.

Steps
 

Choose Policies→Routing→Statement from the NFM-P main menu. The Routing Policy - Statements form opens.


Choose a policy and click Properties. The Routing Policy - Statement form opens.


Click on the Local Definitions tab. The sites the Routing policy statement is distributed to are listed.


Choose a site and click Properties. The Routing Policy - Statement, Site Local Policy form opens.


Click on the Policy Statement Entries tab.


Choose a policy statement and click Properties. The Policy Statement Entry, Routing Policy, Site form opens.


Click on the Action tab.

The Action tab is only available if the Action parameter on the Policy Statement was set to Accept, Next Entry, or Next Policy.


Click Select to choose an interface in the Multicast Redirection panel. The Select Interface - Policy Statement Action - Site form opens.


Select an interface and save your changes. The Policy Statement Entry, Routing Policy, Site form reappears.


10 

Save your changes and close the form. The Policy Statement Entry, Routing Policy, Site form reappears. See To release and distribute a policy to release and distribute the policy to NEs.

End of steps