To configure an administrative group policy

General Information

See Administrative Group policies in this chapter for more information.

Steps
 

Choose Policies→Routing→Administrative Group from the NFM-P main menu. The Routing Policy - Administration Group Policy form opens.


Click Create or choose a policy and click Properties. The Administrative Group Policy, Global Policy form opens.


Configure the required parameters on the General tab.


Click Apply to save the policy and to access the additional tabs on the form.


Configure the parameters or view the information associated with each tab as required. Table 54-6, Description of Administrative group form tabs describes the tabs you can configure/view.

Table 54-6: Description of Administrative group form tabs

Tab

Description

Local Definitions

Lists Administrative group policies and allows you to manage administrative group policy distribution.

LSPs

Lists and allows you to manage LSPs to which the administrative group has been assigned.

LSP-Path Bindings

Lists and allows you to manage LSP paths to which the administrative group has been assigned.

Interfaces

Lists and allows you to manage interfaces to which the administrative group has been assigned. You can access the following interface types on the sub-tabs:

  • MPLS

  • L3 access

  • network

  • tunnel

P2MP LSPs

Lists and allows you to manage P2MP LSPs to which the administrative group has been assigned.

Route Next-Hop

Lists and allows you to manage the next-hop to which the administrative group has been assigned.

Flexible Algorithm Definition

Lists and allows you to manage flexible algorithm definitions to which the administrative group has been assigned.

Faults

List and manage alarms related to the administrative group.


Save your changes and close the form. See To release and distribute a policy to release and distribute the policy to NEs.

Note: A routing policy is discovered as local edit only. To synchronize a routing policy with all NEs, you must change the distribution mode of the routing policy to sync with the global policy. See To change the distribution mode of a policy to change the distribution mode of a routing policy.

End of steps