To configure service tunnel required bandwidth for the service
Prerequisites
To configure service tunnel required bandwidth, you must enable the Multi-Segment Tunnel Selection and Service Bandwidth Management checkboxes on the Services tab on the NFM-P System Preferences form. For more information, see the procedure to configure NFM-P system preferences in the NSP System Administrator Guide.
The following prerequisites apply for use of CAC:
-
An LSP must be created between the required NEs. See To create a static LSP or To create a Dynamic LSP.
-
If a Tunnel Selection profile is used, the Tunnel Selection profile must contain MPLS: RSVP. See To create a tunnel selection profile.
-
For CAC on a Static LSP, the LSP must be configured using the NFM-P for all hops.
Static LSPs and hops configured in the NE do not appear complete in the NFM-P.
-
For CAC on an MLPPP port, MLPPP physical links must be created. See To create a physical link.
CAUTION Service Disruption |
Bandwidth management configuration/Static LSP/Physical link is lost if the NE is unmanaged from the NFM-P.
If management is re-started, bandwidth management parameters must be configured again.
Steps
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens. |
2 |
Choose a VLL service and click Properties. The VLL_type Service (Edit) form opens. |
3 |
Click on the Bandwidth tab. |
4 |
Configure the Bandwidth Method parameter. |
5 |
If the Bandwidth Method parameter is set to Input Manually or Calculate from SAPs, configure LSP Path Booking and Service Path Booking parameters. |
6 |
If the Bandwidth Method parameter is set to Input Manually, enter a required bandwidth value for each CoS (see CoS 0 Bandwidth - CoS 7 Bandwidth). If the bandwidth values configured in the service and the site differ, the lower number will be used by the system. |
7 |
Save the changes and close the forms. End of steps |