Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.

Choose a VLL service and click Properties. The VLL_type Service (Edit) form opens.

On the navigation tree, right-click on VLL_type Service and choose Create VLL_type Site and select an NE, or right-click on a site and choose Properties. The VLL_type Site (Create|Edit) form opens.

Configure the required general parameters.

The Enable CE IP Address Discovery parameter is configurable only for VLL Ipipe terminating sites.

On Ipipe sites, the Stack Capability Signaling parameter is configurable only when the Enable IPv6 parameter and the Enable CE IP Address Discover parameters are enabled.

The VLL Site Type parameter is displayed as read-only for the 7950 XRS, as only switching VLL sites are supported.

You must set the VLL Site Type parameter to Terminating if the site is connected to a 7210 SAS-D, 7210 SAS-E, 7210 SAS-K, 7210 SAS-M, 7210 SAS-Mxp, 7210 SAS-S, 7210 SAS-Sx, or 7210 SAS-T.

On 7210 SAS sites:

• the SAP Type parameter is configurable when the VLL Site Type parameter is set to Terminating

• when you configure a 3-plus-tag Epipe service, you must set the SAP Type parameter to qinq-inner Tag-preserve. See Epipe (Ethernet VLL) in VLL service management overview . See To configure a spoke SDP binding on a VLL site and To create a VLL L2 access interface on a terminating site for additional configuration requirements for a 3-plus-tag Epipe service.

• when you configure a VLAN range SAP on the site, you must set the SAP Type parameter to dot1q-range.

On 7210 SAS-X sites, the PBB Epipe parameter is configurable when the VLL Site Type parameter is set to Terminating.

To assign test generation options to the site:

1. Click on the OAM tab, then the Configuration tab.

2. Configure the required Test Generation Options parameters.

Save the changes and close the forms.

End of steps