To configure Ethernet loopback for a VLL Epipe L2 access interface on a 7705 SAR
Purpose
Perform this procedure to configure OAM loopback for an Epipe SAP on a 7705 SAR NE. You can perform individual loopback tests, or enable loopback as part of Y.1564 test configuration. See STM Y.1564 test configuration for more information about Y.1564 tests.
Steps
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens. |
2 |
Choose an Epipe service and click Properties. The Epipe Service (Edit) form opens. |
3 |
On the navigation tree, expand the 7705 SAR site, then right-click on the required L2 access interface and choose Properties. The properties form for the SAP opens. |
4 |
Click on the Ethernet Loopback tab. |
5 |
Configure the required parameters. If you are configuring Ethernet loopback for Y.1564 tests, set the Mode parameter to Internal, and enable the Mac Swap parameter. |
6 |
Save the changes and close the forms. End of steps |