To create a SAP aggregation group on a 7705 SAR Apipe
Note: SAP aggregation groups can be created only on Apipe services that are configured with the ATM VCC or ATM N:1-N>1 VC Type option. See
To create a VLL service for more information about configuring the VC type.
A SAP aggregation group can contain up to 16 SAPs.
Alternatively, you can create SAPs for a SAP aggregation group by right-clicking on the L2 Access Interfaces entry and choosing the newly created SAP aggregation group.
The QoS and Accounting tabs are dimmed when an L2 access interface is assigned to a SAP aggregation group. The QoS and accounting policies that are assigned to the SAP aggregation group are automatically assigned to all of the SAPs in the group.
Steps
|
|
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.
|
2 |
Choose an Apipe service with at least one 7705 SAR site and click Properties. The Apipe Service (Edit) form opens.
|
3 |
On the navigation tree, expand Site, right-click and choose Properties. The Site (Edit) form opens.
|
4 |
Click on the SAP Aggregation Group tab.
|
5 |
Click Create. The SAP Aggregation Group (Create) form opens.
|
6 |
Configure the required general parameters.
|
7 |
To configure QoS:
-
Click on the QoS tab.
-
Select an ingress policy for the SAP aggregation group in the Ingress Policy panel.
-
Select an egress policy for the SAP aggregation group in the Egress Policy panel.
|
8 |
To specify an accounting policy:
-
Click on the Accounting tab.
-
Select an accounting policy in the Accounting Policy panel.
-
Configure the Collect Accounting Statistics parameter.
|
9 |
Save the changes and close the form.
|
10 |
From the service navigation tree, expand the entries of the 7705 SAR site.
|
11 |
Right-click on the newly created SAP Aggregation Group entry and choose Create L2 Access Interface. The L2 Access Interface (Create) form opens.
|
12 |
Configure the required general parameters.
|
13 |
Click on the Port tab.
|
14 |
Select a terminating port for the L2 access interface in the Termination Port panel.
|
15 |
Configure the required parameters.
|
16 |
Click on the ATM tab and configure the required parameters.
|
17 |
Click on the QoS tab and select an ingress and egress ATM policy in the Ingress and Egress ATM Policy panels.
|
18 |
Save the changes and close the forms.
End of steps |