To configure anti-spoofing filters for a VPLS L2 access interface

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPLS and click Properties. The VPLS Service (Edit) form opens.


On the service tree, expand Sites→site→L2 Access Interfaces.


Right-click the L2 access interface and choose Properties. The VPLS L2 Access Interface (Edit) form opens.


Click on the Anti-Spoofing tab.


Configure the required parameters.

The ARP Reply Agent parameter is configurable only when an IP address is specified for the static hosts on the SAP.


Click on the Static Hosts tab to configure a static subscriber host entry for each subscriber host that is not managed by DHCP.


Click Create. The Access Interface Anti-Spoofing Static Host Display (Create) form opens.


Configure the required parameters.

Note: You must specify at least one IP address or MAC address for each static host. The values that are specified for the Anti-Spoofing and ARP Reply Agent parameters determine the type of address entry that is required for the static host. For example, if you set the Anti-Spoofing parameter to Source Ip Addr, you must specify at least the IP address for the static host.


10 

To configure residential subscriber management for the static host:

  1. Select a subscriber profile for the static host in the Subscriber Profile panel.

  2. Select a subscriber profile for the static host in the Subscriber Profile panel.

  3. Select an SLA profile for the static host in the SLA Profile panel.

  4. Select an application profile for the static host in the Application Profile panel.


11 

Save the changes and close the forms.

End of steps