To configure an LI IP filter policy

Steps

Note: You are required to be an NFM-P user with LI privileges to access the LI IP filter policy.

You require at least one IP filter policy to complete this procedure. See To configure an ACL IP filter policy for more information.

You require at least one Block Reservation policy to complete this procedure. See To configure a Block Reservation policy for more information.

 
1 

Choose Policies→Filter→LI Policies→LI IP Filter from the NFM-P main menu. The LI IP Filter Policies form opens.

2 

Click Create or select a policy and click Properties. The LI IP Filter (Create|Edit) form opens.

3 

Configure the required general parameters.

4 

Configure one or more filter entries:

  1. Click on the LI IP Filter Entries tab.

  2. Click Create. The Entry, LI IP Filter (Create) form opens.

  3. Configure the parameters.

  4. Click on the Filter Properties tab.

  5. Configure the Protocol parameter.

  6. Configure the parameters in the Match Criteria panel.

    The Source Port and Dest Port parameters are configurable only when the Protocol parameter is set to TCP or UDP.

  7. Save the changes and close the form.

5 

Associate the base IP filter with the LI IP filter:

  1. Click on the IP Filter Association tab.

  2. Click Create. The LI IP Filter Association (Create) form opens.

  3. Select an IP filter in the IP Filter panel.

  4. Save the changes and close the form.

6 

Click Apply.

7 

Click on the General tab.

8 

Click Switch Mode to release the policy for distribution. The Release - LI IP Filter Policy form opens.

9 

Choose the NEs in the Available Objects to which you want to distribute the policy and click the arrow to move the NEs to the Selected Objects panel.

10 

Click Distribute and close the form.

11 

Close the LI IP Filter Policies form.

End of steps