To configure an LI IPv6 filter policy

Steps

Note: You are required to be an NFM-P user with LI privileges to access the LI IPv6 filter policy.

You require at least one ACL IPv6 filter policy to complete this procedure. See To configure an ACL IPv6 filter policy for more information.

You require at least one Block Reservation policy to complete this procedure. See To configure a Block Reservation policy for more information.

 
1 

Choose Policies→Filter→LI Policies→LI IPv6 Filter from the NFM-P main menu. The LI IPv6 Filter Policies form opens.

2 

Click Create or select a policy and click Properties. The LI IPv6 Filter (Create|Edit) form opens.

3 

Configure the required general parameters.

4 

Configure one or more filter entries:

  1. Click on the LI IPv6 Filter Entries tab.

  2. Click Create. The Entry, LI IPv6 Filter (Create) form opens.

  3. Configure the required general parameters.

  4. Click on the Filter Properties tab.

  5. Configure the Protocol parameter.

  6. Configure the parameters in the Match Criteria panel:

    The Source Port and Dest Port parameters are configurable only when the Protocol parameter is set to TCP or UDP.

  7. Save the changes and close the form.

5 

Associate the base IPv6 filter with the LI IPv6 filter:

  1. Click on the IPv6 Filter Association tab.

  2. Click Create. The LI IPv6 Filter Association (Create) form opens.

  3. Select an IPv6 filter in the IPv6 Filter panel.

  4. Save the changes and close the form.

6 

Click Apply.

7 

Click on the General tab.

8 

Click Switch Mode to release the policy for distribution. The Release - LI IPv6 Filter Policy form opens.

9 

Choose the NEs in the Available Objects to which you want to distribute the policy and click the arrow to move the NEs to the Selected Objects panel.

10 

Click Distribute and close the form.

11 

Close the LI IPv6 Filter Policies form.

End of steps