To create a mirror service

Before you begin

If you are configuring mirror services using dot1q or QinQ SAPs on a 7210 SAS (except for a 7210 SAS-D or 7210 SAS-K), then you must first assign a no-service mirror port. See To configure a mirror port on a 7210 SAS .

Steps
 

Choose Create→Service→Mirror from the NFM-P main menu. The Mirror Service (Create) form opens.


Configure the required general parameters.

The Service ID and SVC Mgr Service ID parameters are configurable when the Auto-Assign ID parameter is disabled.


If you enabled the Automatic SDP Binding Creation parameter, select a tunnel selection profile in the Auto SDP Binding Creation panel.


To configure a mirror source on a destination site, perform To create a destination site on a mirror service .


To configure a mirror source on a site other than the destination site, perform Step 3 to Step 12 of To create a source site on a mirror service . Otherwise, go to Step 6 .


Save the changes and close the forms.

End of steps