To create and run a MPLS P2MP LSP trace OAM diagnostic test from the STM

Steps
 
1 

Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens.

2 

Click Create and choose MPLS→P2MP LSP Trace. The P2MP LSP Trace (Create) form opens.

3 

Configure the required parameters.

4 

Click Select in the P2MP Dynamic Lsp panel to choose the P2MP Dynamic LSP you want to test.

5 

Click on Select in the P2MP Instance panel to choose the P2MP Instance you want to test.

6 

Click on Select in the S2L Destination Address panel to choose the S2L Destination Address you want to test.

7 

Click on the Test Parameters tab and configure the required parameters.

8 

Click on the Results Configuration tab and configure the required parameters.

9 

As required, click on the NM Thresholds tab to configure threshold-crossing alarms. See To configure threshold-crossing alarms or NM threshold-crossing alarms for an OAM diagnostic test or STM test policy for more information.

10 

Click OK to save the changes. The Service Test Manager form opens.

11 

Choose the created test from the list of OAM diagnostics and click Properties.

The P2MP LSP Trace (Edit) form opens.

12 

Click execute to start the P2MP LSP trace. A deployed test is created and run. Open the deployed test to view its current state. When the test is complete, the deployed test is removed, and you can view the results.

13 

Click on the Results tab.

14 

Select the test from the list and click on Properties. The P2MP LSP Trace Result form opens.

The General tab displays the test parameters you configured, along with time the test was executed and its status.

Note: The test results depend on the type of test you run. See To view and compare OAM diagnostic test results on the STM for more information.

15 

Click on the Hops and Probes tab.

A tree view of the Hops and Probes associated with this test is provided.

16 

Right-click on a Hop from the tree view and click on Properties.

The P2MP LSP Trace Hop (Edit) form is displayed, showing the General tab.

17 

View the test results for the following:

  • Response Probe

  • Round Trip Details

  • Outbound One Way Trip Details

  • Inbound One Way Trip Details

18 

Right-click on a Probe from the tree view and click on Properties.

The P2MP LSP Trace Probe (Edit) form is displayed, showing the General tab.

19 

View details on the probe, including:

  • Response Probe

  • LSP Details

20 

Repeat this test for all required S2L paths. The test only evaluates one S2L path per execution.

End of steps