To run the F5 OAM loopback diagnostic test from a 7705 SAR-M/ME Properties form

Procedure support

This procedure is only supported on the 7705 SAR-M/ME equipped with a DSL module.

Note: The parameters for the F5 OAM loopback test are only visible when the DSL module for the 7705 SAR-M/ME is connected to an ISAM device with the bonding type of ATM and the device is operationally up.

Steps


1	Choose Equipment from the navigation tree view selector. The navigation tree displays the Equipment view.
2	Navigate to the port object where you want to configure an Ethernet port. The path is Network→NE→Shelf→Card Slot→Daughter Card Slot→Port n/n/n.
3	Right-click on the Port icon and choose Properties. The Physical Port (Edit) form opens.
4	Click on the DSL tab.
5	Choose Active for the F5 Oam Loopback parameter.
6	Click Apply to save your changes. A confirmation window opens.
7	Click Yes. The loopback test is executed. If the test was successfully executed, the F5 Oam Loopback Status field displays Pass and the F5 Oam Loopback Time field displays the time it took for the test to execute in milliseconds.
8	View the results from the F5 OAM Loopback test by opening a Telnet session on the NE, if required. See To open and close an NFM-P device CLI session . End of steps