Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager (STM) form opens.

Choose Test Suite (Assurance) from the object menu.

Click Search, then choose a test suite in the list and click Properties. The Test Suite (Edit) form opens with the General tab displayed.

Click Execute. The test suite begins to run. You can view the test results when the test is complete.

Note: You can run an OAM validation test from the properties form of a service tunnel or an applicable service. See the applicable service management chapter for more information.

Note: When you execute a test suite from the properties form of an applicable service, only the tests belonging to that service will be executed. Tests within the suite, but not associated with the current tested entity, will not be executed.

Note: When you execute a test suite under the tested entity (by clicking Execute under the entity’s Tests>Test Suite sub-tab), NFM-P will create a Tested Entity Result under the entity’s Tests>Tested Entity Result sub-tab.

Note: You can click Delete All Result in either the Results tab or the Individual Test Results tabs to remove all listed test results. Alternatively, you can use the Quick Filter on the test result tab pages to narrow down and limit the displayed results. Clicking Delete All Result will then only delete the filtered results. If no filter condition is specified, then clicking Delete All Result will delete all the pages of results, not just the currently displayed page.

Note: If the list under either of these tabs contains more than 1000 entries, only 1000 entries are displayed at a time, with paging available for the remainder. However, clicking Delete All Result deletes all pages of results, not just the currently displayed page.

Close the Test Suite (Edit) form.

End of steps