To add a PIM interface to an IES
Note: Before you can add a PIM interface to an IES, PIM must be applied to All or IES during the PIM configuration at the routing instance level. See
To configure PIM on a routing instance for more information.
Steps
|
|
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.
|
2 |
Choose an IES and click Properties. The IES Service (Edit) form opens.
|
3 |
On the service tree, expand the Sites icon and click on a site. The IES Site (Edit) form opens.
|
4 |
Click on the Multicast tab.
|
5 |
Click Add. The Create Interface form opens.
|
6 |
Set the What type of interface would you like to create? parameter to PIM.
|
7 |
Click OK. The PIM Interface (Create) form opens.
|
8 |
Select an interface and configure the required parameters.
|
9 |
Click on the Behavior tab and configure the required parameters.
The Sticky DR Priority parameter is configurable when the Sticky DR parameter is enabled.
|
10 |
To add a multicast CAC policy:
-
Click on the Multicast CAC tab.
-
Select a multicast CAC policy in the Multicast CAC Policy panel.
-
Configure the required parameters.
-
Click on the Levels tab and click Create. The Multicast CAC Level, IGMP Interface (Create) form opens.
-
Configure the parameters and close the form.
-
Click on the LAG Port Down tab and click Create. The LAG Port Down, IGMP Interface (Create) form opens.
-
Configure the parameters and close the form.
|
11 |
Click on the IPv6 Specifics tab and configure the IPv6 Administrative State parameter.
|
12 |
Close the forms.
End of steps |