To bind an IES L3 access interface to a VPLS site or VPLS I-site

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose an IES and click Properties. The IES Service (Edit) form opens.


On the service tree, expand Site→L3 Access Interfaces, right-click on the L3 access interface you want to modify and choose Properties. The IES L3 Access Interface (Edit) form opens.


Click on the Routed VPLS tab.

Note: You can create and manage a routed VPLS connector from the navigation tree on the Composite Service (Edit) form.


Enter a VPLS site name or select a VPLS site.

The site that you select must be enabled for RVPLS; see To configure a VPLS site.

The operational state of the IP interface binding will not be turned up until the Enable IP Interface Binding parameter is set to true.


Expand the Ingress or Egress panels as needed.


To configure the filter policies:

  1. Select an IPv4 filter in the IPv4 Filter panel.

  2. Select an IPv6 filter in the IPv6 Filter panel.


To enable table-based color-aware ingress classification, select the Enable Table Classification For VPLS parameter, then select a 7210/7250 DSCP classification policy as the Routed Override QoS policy. See Table-based ingress classification on the 7210 SAS.


Select an egress QoS policy in the Egress - QoS Policy panel.


10 

Save your changes and close the forms.

End of steps