To apply OSPF, RIP, or IS-IS to an IES L3 interface
Note: OSPF, RIP, or IS-IS must be enabled at the routing instance level before you can apply OSPF, RIP, or IS-IS to an L3 interface.
Steps
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens. |
2 |
Choose an IES and click Properties. The IES Service (Edit) form opens. |
3 |
Click on the Interfaces tab, then on the L3 Access Interfaces tab. |
4 |
Choose an L3 interface in the list and click Properties. The L3 Access Interface (Edit) form opens. |
5 |
Click on the Protocols tab and click Create. The Create Interface form opens. |
6 |
Specify the interface type by configuring the What type of interface would you like to create? parameter. |
7 |
Click OK. The Interface (Create) form opens. See Routing protocol configuration workflow and procedures for information about configuring specific routing protocols. End of steps |