To view and configure residential subscriber hosts on a SAP
Purpose
Use this procedure to retrieve the residential subscriber hosts configured on a single SAP. You can view the configuration of individual subscriber hosts for troubleshooting purposes, and make configuration changes where required.
Note: The NFM-P retrieves active host data directly from NEs and displays results only after all of the hosts have been retrieved. Because this process can take minutes, Nokia recommends that you specify a single SAP address when searching subscriber hosts. Although it is possible to search subscriber hosts for an entire site or service ID, the time required could cause the NFM-P GUI to timeout before the search process completes, with no search results displayed. Searching without specifying a SAP should be reserved for LNS or WiFi Offload subscriber hosts.
Steps
1 |
Select Manage→Residential Subscribers from the NFM-P main menu. The Manage Residential Subscribers form opens. | ||
2 |
Select Residential Subscriber Host in the drop-down list. | ||
3 |
Select the site ID, service ID, and SAP from which you want to retrieve subscriber hosts. | ||
4 |
Click Search to retrieve the subscriber hosts. | ||
5 |
To view the information for a subscriber host, select the host entry and click Properties. The Subscriber Host form opens with the subscriber host information displayed. If you need to make configuration changes to the subscriber host, proceed to the remaining steps in this procedure. Otherwise, close the forms. | ||
6 |
Changing the subscriber profile string directly on a subscriber host is potentially service-affecting to all hosts on all SAPs that belong to the subscriber. Because a subscriber is associated with only one subscriber profile, when you change the subscriber profile string for one host, all dynamic or PPPoE hosts associated with the subscriber on all SAPs are automatically configured with the new subscriber profile. Configure the Subscriber Profile String parameter for the dynamic host or PPPoE host, if required. Select a subscriber profile string, or simply type a subscriber profile string in the field. | ||
7 |
Configure the SLA Profile String parameter for the dynamic host or PPPoE host, if required. Select an SLA profile, or simply type an SLA profile string in the field. | ||
8 |
Configure the ANCP String and Intermediate Destination ID parameters, if required. | ||
9 |
Configure the parameters on the Subscriber Profile/SLA Profile Aliases panel, as required. | ||
10 |
Configure the Application Profile parameter for the dynamic host PPPoE host, if required. Select an application profile string, or simply type an application profile string in the field. | ||
11 |
Save your changes and close the forms. End of steps |
