To configure an SPB access interface

Steps
 

Perform one of the following:

  1. To configure an OmniSwitch LAG as an SPB access interface, continue to Step 2 .

  2. To configure an OmniSwitch port as an SPB access interface, go to Step 6 .


Create an OmniSwitch LAG as described in To configure an OmniSwitch LAG .


On the equipment tree, expand Device→LAG.


Right-click on the LAG object and choose Properties. The LAG (Edit) form opens.


Go to Step 9 .


On the equipment tree, right-click on an OmniSwitch object and choose Properties. The Network Element (Edit) form opens.


On the equipment tree, expand Shelf→Port.


Click on the required port. The Physical Port (Edit) form opens.


Set the Mode parameter to Access and click Apply to confirm.


10 

Set the SPB Service Mode parameter to Enabled.


11 

Configure the Description and Vlan Xlation Mode parameters in the Service Access Info panel.


12 

Click Apply to confirm.


13 

Click on the Policies tab and select a UNI profile in the UNI Profile panel.

Note: If no UNI profiles exist, perform To configure an OmniSwitch Ethernet service UNI profile to create one.


14 

Select an L2 profile in the L2 Profile panel.

Note: If no L2 profiles exist, perform To configure an OmniSwitch Ethernet service L2 profile to create one.


15 

Close the form.

End of steps