To configure a virtual port using the navigation tree

Steps
 

On the Equipment navigation tree, expand NE→Shelf→Card Slot→Daughter Card Slot, right-click on an access/hybrid Ethernet port and choose Properties. The Port (Edit) form opens.

This applies to ports on the IOM3 and IMM on the 7750 SR, 7750 SR-c4 and 7450 ESS.


Click on the Egress Scheduling Virtual Port tab.


Click Create. The Egress Scheduling Virtual Port (Create) form opens.


Configure the required general parameters.


Select a port scheduler policy in the Port Scheduler Policy panel.

You cannot select a port scheduler policy for the virtual port if you have already selected a port scheduler policy for the associated channel. Likewise, selecting a port scheduler policy for the virtual port prevents you from selecting a port scheduler policy for the associated channel.


Select a scheduler policy in the Scheduler Policy panel.


If you did not select a scheduler policy in Step 6 , configure the parameters in the Aggregate Rate Limit panel.

The Limit Unused Bandwidth parameter is only available on access ports and on SONET channels when an ATM MDA is used.


Configure the Status parameter in the Egress Rate Modify panel.


Configure the parameters in the Hardware Aggregate Shaper Scheduler panel.

  1. Enter the Displayed Name parameter.

  2. Select Enable to monitor the hardware aggregate shaper scheduler mentioned in the previous step.


10 

Click on the Host Matching tab.


11 

Click Create. The Host Matching (Create) form opens.


12 

Configure the Destination String parameter.


13 

Save your changes and close the forms.

End of steps