To create a standard VLAN service on OmniSwitch devices

Note: Nokia recommends that you specify the OmniSwitch ports that will be network interfaces before you configure a standard VLAN service.

Steps
 

Choose Create→Service→VLAN from the NFM-P main menu. The VLAN (Create) Service form opens.


Select a customer to associate with the VLAN.


Configure the required general parameters.

The Service ID and SVC Mgr Service ID parameters are configurable when the Auto-Assign ID parameter is disabled.


Click on the VLAN tab and set the Application parameter to Standard VLAN.


Select a group to associate with the VLAN in the Group panel.


On the service navigation tree, right-click on VLAN and choose Create VLAN Site to choose a site for the VLAN. The Site (Create) form opens.


Configure the required general parameters.


Click on the VLAN tab and configure the required parameters.


Perform To associate an access interface with a VLAN service to create one or more access interfaces on the site.


10 

To enable DHCP/DHCPv6 snooping on the VLAN:

  1. Click on the DHCP/DHCPv6 Snooping tab.

  2. Click Create. The VLAN Level DHCP/DHCPv6 Snooping (Create) form opens.

  3. Configure the required parameters.

    These parameters are automatically enabled when DHCP/DHCPv6 snooping is enabled on a VLAN.

  4. Save the changes and close the form.


11 

To add one or more static entries to the DHCP binding table:

  1. Click on the Binding Database tab.

  2. Click Create. The DHCP Snooping Binding Database (Create) form opens.

  3. Configure the MAC Address parameter.

  4. Select a port.

  5. Configure the required parameters.

  6. Save the changes and close the form.


12 

Save the changes and close the forms.

End of steps