To configure an MPLS-TP static pseudowire on a VPRN spoke SDP binding

Purpose

Perform this procedure to create an MPLS-TP static pseudowire on the spoke SDP binding. An MPLS-TP service tunnel must be used in the SDP binding, and the Control Word parameter for pseudowire OAM must be set to Preferred. See To create an L2 SDP spoke termination on a VPRN service .

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Select a VPRN and click Properties. The VPRN Service (Edit) form opens.


On the service tree, expand Sites→Routing Instance→Spoke SDP Bindings, right-click on the spoke SDP binding you need to configure and choose Properties. The Spoke SDP Binding (Edit) form opens.


Click on the Control Channel tab.


Configure the required parameters.


Configure the static PW:

  1. Click on the Static PW tab.

  2. Click Create. The PW Path ID (Create) form opens.

  3. Configure the Path AGI parameter.

  4. Configure the parameters in the Source Attachment Individual Identifier panel.

  5. Configure the parameters in the Target Attachment Individual Identifier panel.

  6. Click OK. The PW Path ID (Create) form closes.


Save the changes and close the forms.

End of steps